Driving a fluorescent tube

Even if a fluorescent tube it's not a neon glow lamp and this page it's not maybe at the right place, this circuit is very interesting because it uses an odd way to power a very common lamp.
Like glow lamps, neon tubes are composed by two electrodes in a low pressure atmosphere composed by a mixture of gazes; usually argon and mercury producing UV light that is converted into white light by a fluorescent layer on the internal surface of the tube. When the tube is off no current can flow through it when the voltage between its electrodes is lower than a threshold voltage (it varies with the length of the tube from about 300 V for the smallest ones, up to more than 10 kV for the longest ones). To reduce this voltage by a factor of 10 and make the tube start better the electrodes are often heated by a current flowing through them. Depending on the start circuit this current may (or may not) be shut off after the tube has started.
Once the tube is lit, the voltage between its electrodes falls and remain roughly constant even if the current is varied (between 30 and 100 V depending on the length of the tube and on the gas inside).

Diagram of the lamp

Fluorescent tubes are often powered with AC current, but with this circuit we will drive it in DC. Basically this circuit is a voltage doubler (composed by the two diodes 1N4007 and the two high voltage electrolytic capacitors of 10 uF - 350 V) that generates, when the tube is off, a DC voltage of more than 600 V from a 230 Vac main. Unfortunately this circuit doesn’t work with a 110 Vac main. If a low power tube is used (for example 4, 8 or 12 W) these 600 V are enough to strike the it.
Once the tube lit, a current starts flowing through the two capacitors of 470 nF - 630 V that causes a voltage drop that ensures the service voltage of about 30 V for the tube.
The 1 MOhm resistor and the two 470 kOhm resistors are useful for discharging the capacitors when the circuit is switched off. If not discharged, the energy stored in the capacitors could be lethal even when the circuit is unplugged. Since the lamp is directly connected to the main, one should avoid touching any part of it and be very careful anyway.
The 82 Ohm resistor is used to reduce the current spike when the circuit is switched on and all the capacitors are still discharged.
A metal plate near the tube connected to the ground makes the tube easier to start.

Since in this case the electrodes are not heated, starting the tube can be a little difficult when the lamp is old or too long. Touching the tube with one hand usually helps (with a little help of my hand I could light a 22 W tube). But be extra careful and just touch the glass of the tube; it's very dangerous to touch any other part of the circuit.
When the lamp is lit, one can remark that the negative electrode (in the picture on the left) is darker than the positive one: this is due to the Faraday dark zone, that is only visible when the tube is powered with DC current.

Picture of the lamp (lit)

Home

Electronics

Index